Friends, today in this article I am going to give you information about walk through energy audit in a very good way. So let’s start.
walk through energy audit
This is a general energy audit. Under this, energy audit is directed during inspection in any project or industry. In this inspection, it is seen whether the technical equipment used in the project and their functioning are working properly or not. The efficiency of all the equipment present in the work area can be tested under this process and if required, instructions can also be given to replace these equipment.
Under the walk-through energy audit of a building, first of all the entire work area is inspected and the corrective points are marked. These points are selected on the basis of the basic principle of energy conservation.
These points are clearly displayed in the energy audit report for current status and corrective status.
The auditor working in this process of energy audit needs to have complete technical knowledge, because all the reports are prepared as per the inspection of the auditor. Under this type of audit, all the sections are inspected separately and displayed, for example, during energy audit in a building, the inspection chart for structural audit is different, while the performance charts of electrical load and equipment used are used separately. Due to separate audits in each section, it is possible to conduct a detailed audit.
Following are the major steps in walk through energy audit-
- Preparation and Planning – First of all, a plan is made to set goals in the audit process. These goals mainly include reducing energy bills, increasing energy efficiency, etc.
- Site Inspection – This is the most important phase of a walk-through audit because energy conservation opportunities are identified through a walk-through site inspection. In a site inspection, all working systems are inspected.
- Data Collection and Analysis – After site inspection, data is collected and analyzed. Under this, the causes of energy loss are found by keeping in mind the points of loss. A detailed report is prepared for this.
- Cost-Profit Analysis- This step is calculation based, under which the final report is prepared using the data. This report shows the annual savings and additional energy consumption by the resources.
What did you learn today :-
Now you must have known that through Walk Through Energy Audit, you must have got the answer to all these questions very well.
I hope you liked the information given by me, if you have any question/suggestion in your mind, then you can tell me by commenting below, I will definitely reply to your comment. If you liked this post, then you can also share it with your friends and relatives.